On boot up and via Mavlink connect to MP I see this message:
The Multirotor is flying presently ok and I can configure parameters via the Mavlink / sik radio system which is still working ok. The Windows 8.1Pro laptop I’m using works fine configuring my 4 other drones but does require the Impulse RC driver fixer sometimes when swopping from one drone to another. Along with trying several different USB cables. This tried also with the reset button pressed at power up. Nothing found by Impulse RC driver fixer.Īlso I’ve tried to boot with the SD card removed with the same result as above. I just get a triple beep and still no com port visible by latest versions MP, QGC or iNav configurator. I’ve tried to boot into DFU mode by powering on with the reset button pressed. Previously I was running ArduCopter 3.6.2 on ChibiOS, the USB showing as Com 11.Īfter flashing with the latest master I’ve lost the com port. Recently I’ve purchased the DJI FPV system kit and was motivated to upgrade the Multirotor with it and utilise the custom OSD via the new MSP protocol support coded in the latest master for Pixhawk 1. I’ve been flying this FC in a Multirotor for two years successfully.
0 kommentar(er)
